The Orbi router and satellite connection is built by the sync button wirelessly but with the modem it is with the ethernet cable. So, if your RBR20 router is facing issues like intermittent WiFi connection or it is keep disconnecting, you can apply these tips given below:
Remember in case of, no tip has worked then you must reset the router and re-do the Orbi RBR20 Router setup the device again from the Orbi app or orbilogin.net.
You must check that the WiFi router is connected with the modem via Ethernet cable or not. Check if there is any damage or loose ends. If damage found replace the cable with a new one.
Also make sure that the satellites are connected or not with router. in case of no connection, Sync Orbi satellite again. To sync, just press the sync button on the back of the satellite & router.
You should refresh the Orbi RBR20 router’s settings that might solve the problem. You can do it by cutting the power to the extender and supply it again. There are two ways to do it:
The Orbi router and satellite’s LED (ring & power) are there to show the status of the device connectivity and power supply. So, there should be any indication about the intermittent connection on the power LED or on the Ring LED. The indication can be:
You can manually or set the updates on auto from the interface or Orbi app. let’s how you can do it:
Open and access the Orbi router app with the help of the MYNETEGAR account. If you haven’t registered your device, you can enter the default Orbi RBR40 login admin username and password.
Download the Orbi firmware update file on the official website of the Netgear support. And after that follow these instructions:
You have to find the reset button first > Press it with the Pin or pen and hold it for about 10 seconds > By releasing the button, the reset process will start > After a few minutes, it will end and you can re-do the setup through the orbi router login.
Here, you have seen how to troubleshoot Intermittent WiFi on Orbi RBR20 Router with the help of major solutions and tips. Hope, you have resolved it and connected to the network.
You have to press the Sync button on the back of the router and satellite once. Then wait until the blue light has showed on the satellite’s Ring LED. It means the connection is established and strong.
find the reset button first on the back of the satellite > Press it with Pin or pen and hold it for about 10 seconds > By releasing the button, the reset process will start.
Disclaimer: We hereby disclaim ownership of any product and any association, affiliation or representation in any form, of any brand, product or service. All the information provided here has been drafted by a team of highly qualified technical experts and regularly undergo reviews and updates.