Orbi CBR40 modem router is one of the best networking devices that Netgear Orbi series have in the collection. You can connect it directly with the ISP and turn it on as a router from inside the interface.
But users are having a problem which is common and is resolvable. Here, in this blog, we will present you reasons and solutions to this issue “Orbi CBR50 no modem lights and will not connect to internet.”
Check the power brick and make sure it’s seated right. Power adapters that comes with the Orbi can go halfway out of the wall or the router, and you’ll get no lights at all. If you’ve got a surge protector, try plugging it directly into the wall instead.
If it was working fine and then suddenly just went dead, there’s a solid chance it bricked itself during an update. Sometimes Orbi auto-updates in the middle of the night, and if there are power cuts in between, the Orbi router login firmware issue will come.
The lights might not come on even though the adapter “feels” like it’s working. If you’ve got a spare adapter with the same voltage and amperage, test it.
The CBR40’s a combo unit (router + cable modem), so if the modem section croaks, you’ll lose the internet even if Wi-Fi looks okay. Sometimes the front lights won’t even show modem status anymore. At that point, you can still log in at orbilogin.com (if the router part’s alive) and check if it says “no cable connection” or “offline.” If it won’t load at all, the whole unit might be gone.
If the lights do come on but stay amber or blink endlessly, your line might be down or the MAC address got unregistered by your ISP. Call them and have them “reprovision” the modem. Tell them you’ve got a Netgear Orbi CBR40 gateway, and you need them to push activation again.
That’s hardware. Either the power supply died or the board’s gone. Try a new adapter first—it’s cheap.
That’s usually a power supply issue. The adapter might be shot. Grab a voltmeter if you have one — should read around 12V DC. If not, you’re going to need a new power adapter. Same voltage, at least 3.5A output.
There’s a tiny Orbi factory reset pinhole on the back — hold it down for 15 seconds (use a paperclip). Release it, and wait. It takes a couple of minutes to reboot itself.
Okay, so the modem lights come on now but you still can’t get online — that’s a different story. The CBR40 is a combo unit (modem + router), so it talks directly to your ISP’s line. Pull the coax cable out, check for damage or looseness. Hand-tighten it, don’t wrench it down. Then power-cycle the whole thing: unplug power, wait 30 seconds, plug it back in.
Log into your ISP account (Xfinity, Cox, whatever) and see if your modem is actually “activated.” These combos Orbis need to be provisioned on their end. You might have to call them and give them the MAC address off the sticker on the bottom. Tell them it’s an Orbi CBR40 gateway. They’ll walk you through reactivation — takes like five minutes.
If it powers on but just sits there blinking amber, go to Netgear’s support site, grab the latest firmware for the CBR40, and use their Nighthawk app or the manual upload via Ethernet method. You’ll need to plug straight into it with a laptop and use the router login (usually 192.168.1.1 or orbilogin.com).
Hope this post have provided you the correct solution to fix the problem like “Orbi CBR50 no modem lights and will not connect to internet.”
Disclaimer: We hereby disclaim ownership of any product and any association, affiliation or representation in any form, of any brand, product or service. All the information provided here has been drafted by a team of highly qualified technical experts and regularly undergo reviews and updates.